Sealing leakage in transformer repairing, chipped porcelain insulators and bushing. To seal the contact between lug of jumper and transformer bushing stem to prevent oxidation. To seal enclosure of the choke and fuse unit of mercury lamps. To seal motor terminals to prevent loosening of connection due to vibration & subsequent heating. Balancing of motors and armatures, for moisture proofing in cable joints made with CI & plastics.

The surface should be free from dust, rust, oil, paint, varnish, moisture etc. Emery paper or grinder can be used to abrade the surface for better binding. Acetone, petrol, kerosene oil can be used to free the surface from grease/oil. Twist or cut off required amounts; to mix, knead with fingers to form a uniform color. If mixing is difficult, warm the putty to room temperature or slightly above. Apply to surface to be repaired within 2 minutes of mixing. Force into any cracks or holes to be filled and strike off the excess material, preferably with a tool dampened with clean water. When applying to a damp or wet leaking area, work the material forcefully and apply the pressure until adhesion begins to take effect. For a smooth appearance of the cured compound, hand rub with water or a damp cloth prior to hardening. Remove excess material before hardening begins. After 5-10 minutes the epoxy will begin to form a tenacious bond. After just 60 mins, Bondset Two in One can be drilled, sawed, carved, sanded, stained or painted.